UAS4G5G LTE · START HERE

Write the system image.

Install the correct board image once. Continue with normal updates from inside the program.

THE CONNECTED FLIGHT PLATFORMv23Raspberry Pi
Radxa ROCK 4D
Radxa ZERO 3W / 3E
01

Select the matching image

Your boardImage family
Raspberry PiRaspberry boards image
Radxa ROCK 4DROCK 4D image
Radxa ZERO 3W / 3EZERO 3W/3E image

Keep these image families separate. A shared dashboard does not make their boot configuration, kernel or camera connections interchangeable.

02

The flashing controls

1. Flash from file → 2. Select target → 3. Flash! Choose your extracted UAS image, then the intended SD card. Check the target carefully and wait for validation to finish.

Official balenaEtcher demonstration: choose the image, select the target and flash
Official balenaEtcher interface demonstration. The sample file and drive are illustrative; use your matching UAS image and your intended SD card. Source: balenaEtcher ↗.
03

Flash with balenaEtcher

  1. Download and prepare. Obtain the matching release, extract its .img file and check any checksum provided with the download.
  2. Select the image. Open balenaEtcher and choose the extracted image using Flash from file.
  3. Select the SD card. Confirm the device and capacity carefully. Flashing replaces all content on the selected target.
  4. Flash and validate. Wait for both writing and validation to finish. Do not remove the card or interrupt the computer.
  5. Eject and boot. Safely eject the SD card, insert it into the correct board and power on.

Official balenaEtcher download and instructions ↗

04

After the first boot

Connect to the dashboard, choose trial or activation, and configure your camera and telemetry endpoints. Do not format the Linux partitions if your desktop operating system prompts you to do so.

05

If the board does not start

  • Confirm the image family matches the exact board.
  • Check the power supply, card seating and the result of image verification.
  • Retry with a known-good card or reader if the write was unreliable.
  • For a persistent problem, send the board model, image filename and observed boot behaviour to support.
Program screenshotFull resolution ↗